The Netgear extender firmware update failed issue has managed to frustrate a number of users all across the globe. Are you also unable to update the firmware of your Netgear WiFi range extender via mywifiext net? Well, that isn’t such good news. But, guess what? The hacks highlighted in this post can help you out. Thus, wait no more and get to reading.
Netgear Extender Firmware Update Failed?
Give Your Extender a Restart
We have no shame in saying that this hack is the simplest way of getting rid of the issue at hand. It has helped many. Chances are that it might work for you too. So, why not give it a try? Following are the instructions that will help you in rebooting your extender:
Set the power button on your Netgear extender to OFF mode.
Wait for as long as you can.
Press the power button to switch on your Netgear range extender.
And you are done! Once the rebooting process has been completed by you, try performing Netgear extender firmware update? Did your stars get lucky? No?
Change Your Connection Source
Sometimes, users make silly mistakes while performing Netgear extender firmware update, like connecting their extender and router wirelessly.
There is a possibility that you went and stood in the same queue. So, how to troubleshoot the issue? Well, it’s simple. All you need to do is, switch to a different source. To be more specific, use an Ethernet cable to connect your devices.
Pull Your Devices a Little Closer
If you are not sitting in the same room where the extender is placed, you tend to face issues, right? Well, chances are that something similar has happened with your Netgear extender. By that we mean, it is not placed in the same room as your router.
Therefore, we recommend that you move your devices a little closer. Focus on the word ‘little’ because if you place your devices too close, their signals might clash. And then, we won’t be able to be of any help to you.
Eliminate WiFi Interference
If you are not able to perform Netgear extender firmware update by accessing the mywifiext.net login page, then it’s probably because of unwanted WiFi interference.
WiFi interference can be eliminated if you take our advice, i.e. relocating your Netgear wireless range extender and placing it away from:
If you want to be more on the safer side, then do not keep your device near concrete walls.
Follow the Correct Instructions
This is the topmost reason why we have been trying to help out users in fixing the Netgear extender firmware update failure issue. Think about it, if you won’t the correct instructions, isn’t it obvious that you’ll get stuck with technical issues?
Thus, to rectify your mistake, make sure that you follow the correct guidelines while giving the Netgear firmware update process a go in the future.
Reset Your Netgear Extender
If you still have your head under the axe because of the Netgear extender firmware update, don’t waste any more time restoring your device to its factory default settings.
You can take the help of the following steps in order to reset your extender:
Find the Reset button at the bottom of the device you are using.
Found? You are doing great so far! Now, press it.
Hold on for as long as you feel like it.
Now that you have restored your Netgear wireless extender, consider configuring it from scratch by accessing the mywifiext setup wizard. If you feel like it, you can take references from the guidelines given in the user manual to complete the setup process. Trust us; there is no way that you will regret this thing.
With the last hack, we are wrapping up our post written on troubleshooting the Netgear extender firmware update failure issue. Apart from the hacks mentioned above, if you are acquainted with any other through which the issue at hand can be resolved, don’t mind sharing it with your fellow readers. As far as we think, they might be eager to learn about something new.