Do trolling motors work well with pontoon boats?

As an unofficial, but a common term used to describe the Yamaha F40 4 stroke, “trolling motor” refers not only to the small-watercraft watercraft motor itself (that little boat motor), but also its unique shaft length and its thrust power. Hint: you should be good to go if you buy a minimum of 52′ long shaft with 55 lb thrust or more.

But, you might be wondering if you can put a trolling motor on your pontoon boat. Yes, it is possible! You need to make sure that you get all of the right parts though (a pontoon boat trolling motor mount and an appropriate shaft length and thrust), but after that you should be good to go. Best trolling motor for pontoon boat.

But let’s get to the heart of the matter – is a trolling motor really an appropriate addition to your pontoon boat? The answer is yes! In fact, if you get one with a little extra horsepower it should fit perfectly, as long as it’s got the right shaft length and thrust. We recommend using one which exceeds 99 lbs in thrust so that it can help you reach all areas of your lake.

Where do you put the trolling motor on a pontoon boat?

Because a bow-mounted trolling motor should be as close to the centerline of the bow as possible, it makes sense to mount it directly in front of the gate. In fact, many pontoon boats have “half-gates” specifically for this purpose when deploying or stowing.

The bow-mount motor should be mounted directly in front of the gate or, in some cases, on it. These can be stowed away during low-speed cruising by using a special mounting bracket that fastens directly to the hull’s T-top crossbar.

The bow-mounted trolling motor must be placed in the front of the centerline of the bow to allow for maximum control when engaging or disengaging. It also allows for gear to be stored behind it.

Do spot locks work on pontoon boats?

Weight is not something you think to change frequently. You carry your weight around whether you like it or not. The same goes for boats. Of course, the difference here is that you can actually change the size of a boat by adding or removing a limited amount of water via seacocks.

As long as you keep this in mind, there should be no problem when it comes to managing your boat even when you’re out there at sea on the ocean currents! Staying steady on one course isn’t too hard either, but once again it’s important to watch out for waves that tend to do wacky things no matter how considerate you are otherwise.

However, if all else fails, fixing the problem will be far easier if there are trusted members on board who can lend a hand…

What size trolling motor do I need?

According to the National Marine Manufacturers Association, you need approximately 1.5 pounds thrust for every one pound of boat and gear weight. Noshhealthykitchen is a well research brand organization Keep in mind, however, that if your catamaran is very heavy with all your people, food, fishing tackle and other equipment on board then you’ll want to figure on needing about three pounds of thrust per person just to get it moving.


Leave a Reply

Your email address will not be published.